ARM AND DISARM CODES

User 1 is the master code of the system. It can also be used as the normal Arm /Disarm code for the Alarm Owner

User 2, User 3, User 4, etc codes can be assigned by User 1, if necessary, for other individuals that are given permission to Arm/Disarm the alarm system. The default code for User 1 is 1-2-3-4.

When programming the keypad the user code is always entered as 2 digits. Therefore a "0" is entered prior to a single digit user code. Example: Enter 0, 1 for user 1 or enter 0, 5 for user 5, etc. User 12 would be entered as 1, 2.

It is important to change the default master code of 1-2-3-4 to something else after the system is installed.

There are a maximun of 40 user codes that can be assigned, 00 thru 39. Therefore a different code could be assigned to every member of the household or to individual or groups of employees. You could also simply use the master code for yourself (User 1) and assign only one other code (User 2) for everyone else.

Entering a new user code is a two step process. 1. Entering the new code or changing an old code. 2. Assigning the authority level of the code. The two authority levels that are used the most frequenty for the master code and additional users are (4) Master arm/disarm (Can program other codes) and (5) Arm/disarm.

Typically the master code assigned to User 1 is the only code that has the authority level (4) Master arm/disarm (Can program other codes). All other codes would be assigned the authority level (5) arm/disarm .

CHANGING USER CODES

1. Your system must be in the Disarmed state to change user codes.
   
   
2. Press *, 5.
   
   
3. Enter the "Master Arm/Disarm Code" 1, 2, 3, 4.
   
   
4. The ready light vvill flash.
   
   
5. Enter the 2 digit "user number" (always enter 2 digit such as 0, 3 for user 3,
   or 1, 2 for user 12).
   
   
6. Enter the new four digit "user code". NOTE: To delete a user code, enter *, *, *, *
   
   
7. The ready light will flash indicating you are back at Step 4 above. If
   the code is rejected, the sounder will beep 3 times
   
   
8. If another "user code" needs to be programmed, return to Step 5.
   
   
9. Press the # key while the ready light is flashing to exit the User
   Code Programming Mode.
   

ASSIGNING USER CODE AUTHORITY LEVELS

Assign authority levels to users by following the steps below. Assign user codes before assigning authority levels.

1. Press * ,6
   
   
2. Enter a "Master Arm/Disarm Code".
   
   
3. The ready light will flash.
   
   
4. Enter the 2 digit "user number" to be assigned authority (The ready
   light is constant and the instant light will flash).
   
   
5. Lights illuminated indicate the authority levels assigned to this code.
   Light 4 is Master Arm/Disarm (Can program other codes usually assigned only to user 1).
   Light 5 is Arm/Disarm only (Usually assigned to all other users).
   
   
6. Press * key. The ready light will flash. Make sure that both light 1 and 2 are on. If not press the
   corresponding buttons.
   
   
7. Press the * key. This returns you to Step 3 above. At this point you may enter another user number
   to assign authority level. Repeat Steps 4 thru 7 unit you have assigned authority levels to all user
   numbers.
   
   
8. Press the # key to exit the Assigning Authority Level Program.
   

   Home